This module integrates Electrochemical formaldehyde, Semiconductor VOC sensor, Laser particle sensor, NDIR CO2 sensor and temperature& humidity sensor. (Users could choose CH2O version or VOC version, they are not concomitant.)
Communication Interface: TTL serial/RS485, Baud rate:9600, data bit:8, stop bit:1, parity bit: none.
Sensitive material of MQ-2 gas sensor is SnO2, which with lower conductivity in clean air. When the target flammable gas exist, the sensor’s conductivity gets higher along with the gas concentration rising. Users can convert the change of conductivity to correspond output signal of gas concentration through a simple circuit.
Sensitive material of MQ-5 gas sensor is SnO2, which with
lower conductivity in clean air. When the target flammable
gas exist, the sensor’s conductivity gets higher along with the
gas concentration rising. Users can convert the change of
conductivity to correspond output signal of gas concentration
through a simple circuit.
ZE12A is a general-purpose and high-performance electrochemical module. It can detect the CO, SO2, NO2, O3 based on electrochemical principle,
it has good selectivity and stability.
ME3-NO2 electrochemical sensor detect gas concentration by measuring current based on the electrochemical principle, which utilizes the electrochemical oxidation process of target gas on the working electrode inside the electrolytic cell, the current produced in electrochemical reaction of the target gas are in direct proportion with its concentration while following Faraday law, then concentration of the gas could be get by measuring value of current.
4R-PID is a high-performance photoionization PID sensor. It has the characteristics of high sensitivity, wide detection range and wide spectrum. It can detect thousands of volatile organic compounds (VOCs) and some inorganic vapors in different application fields. The detection range starts from 1ppb and is up to 10000 ppm, with extremely fast response speed and high resolution. It can be used in kinds of portable and fixed instruments and various of analytical instruments.
The F1031V-2 flow sensor uses the thermodynamic
principle to detect flow rate of the gas medium in the
flow channel, with good precision and repeatability.
Temperature sensors are built-in and every one product
is calibrated for temperature compensation. At the same
time, it has linear analog voltage output, convenient to
use.
ME3-ETO electrochemical sensor detect gas concentration by measuring current based on the electrochemical principle, which utilizes the electrochemical oxidation process of target gas on the working electrode inside the electrolytic cell, the current produced in electrochemical reaction of the target gas are in direct proportion with its concentration while following Faraday law, then concentration
of the gas could be get by measuring value of current.
FR03H flow sensor is an upgrading developed from F1012 . It adopts
MEMS Thermal principle to monitor the flow of pipeline gas medium. This
product adopts low pressure loss design and is widely used for all kinds of
gas measurement.
Thank you for your interest in Tangsemi Electronics (Shenzhen) Co.,Ltd products and services. We care about what you think. Please fill out the following form so that we can continue to provide you with the outstanding service you deserve.